Page 1 of 1

NeoSD MVS - only Crosshatch-Screen

Posted: 24 Sep 2018, 17:03
by basitsch
Hello!
My NeoSD MVS arrived today and unfortunately causes problems.
I unpacked the module, formatted an 8GB microSD on FAT32 and converted a ROM via NeoBuilderUI_1.06. Then I put the module into my MVS-1c ( https://de.aliexpress.com/item/NEUE-JAM ... 52119.html ) and turned it on. Unfortunately I only see the Crosshatch test screen, with or without sd card inserted.

Re: NeoSD MVS - only Crosshatch-Screen

Posted: 24 Sep 2018, 17:34
by neodev
Probably the cart is plugged backwards. On a mv-1c, ensure the neosd sticker is facing away from the jamma connector. That is, as if the side without sticker had the usual mvs cartridge arrow (that must be matched with the mvs arrow for insertion.

Re: NeoSD MVS - only Crosshatch-Screen

Posted: 24 Sep 2018, 18:27
by basitsch
Thanks, that's it.
I was a bit confused because the module doesn't have this arrow. I had searched for it, found none and therefore oriented myself towards the label.